StorCase Technology 9-Bay 4U SCSI Ultra320 - Manual (Page 38)

InfoStation User Interface 29
InfoStation 9-Bay User's Guide - Rev. C02 StorCase Technology, Inc.
Insert/Remove Push Button
NOTE: Refer to the InfoStation Installation Guide for detailed information on
inserting/ removing drives from the InfoStation chassis.
The operator must follow the procedures below to remove or insert a drive carrier (with drive
installed) into the InfoStation drive bay.
Inserting a Drive Carrier (with Drive Installed)
NOTES: A new drive can be inserted into an empty bay at anytime. However, the
drive will not be ready for access until the following procedure is
followed.
The key lock is only to prevent unauthorized removal or installation of the
drive carrier. Locking the key lock is not required for drive carrier oper-
ation.
Refer to the InfoStation Installation Guide for detailed information on
inserting/removing drives from the InfoStation chassis.
1. Press and hold the Insert/Remove button in until the Drive Ready LED starts to flash
(approximately 3 seconds).
2. Drive is ready to be accessed when the Drive Ready LED glows instead of flashes.
Removing a Drive Carrier (with Drive Installed)
CAUTION: Proper procedure must be followed when removing a disk drive from the
drive bay. It is the responsibility of the operator to ensure that the host
does not access the drive while attempting to remove the disk drive, and
to follow the procedure outlined below. Failure to do so may result in loss
of data and/or damage to the drive itself!
NOTE: Refer to the InfoStation Installation Guide for detailed information on
inserting/removing drives from the InfoStation chassis.
1. Press and hold the Insert/Remove button in until the Drive Ready LED starts to flash
(approximately 3 seconds).
2. Drive is ready to be removed when the Drive Ready LED is OFF.
3. Unlock the key lock (if locked) and remove the drive carrier by pulling on carrier handle.