StorCase Technology 9-Bay 4U SCSI Ultra320 - Manual (Page 34)

InfoStation User Interface 25
InfoStation 9-Bay User's Guide - Rev. C02 StorCase Technology, Inc.
Fiber Channel Speed Set-Up
The following steps show how to change the InfoStation Fibre Channel Speed.
NOTE: Press CANCEL at anytime to exit the menu system and return to the Default
Display. The menu system will automatically cancel after 15 seconds of
User inactivity.
NOTES: FC Speed 0 = 1Gbps
FC Speed 1 = 2Gbps
Factory default is 2Gbps (FC Speed 1).
ENTER
S t a t u s
S e t u p
T E M P : x x C
E n c . I D
ENTER
DOWN
ENTER
DOWN
F C S p e e d
UP/DOWN
F C S P D = 0
F C S P D = 1
F C S P D = 0
ENTER
1. Press ENTER at the Default Display so that
display = Status.
2. Press DOWN until display = Setup.
3. Press ENTER so that display = Enc. ID.
4. Press DOWN until display = FC Speed.
5. Press ENTER so that display = FC SPD=1.
This is the current Fibre Channel speed.
6. Press UP or DOWN to change the Fibre Channel
speed.
7. Press ENTER to accept the change.