StorCase Technology DS90 - Manual (Page 16)

10 Installation
Kingston Technology Company DS90 User's Guide - Rev. C00
Figure 9: Installing the Drive onto the Mounting Bracket
2. Attach the drive to the mounting bracket using the 6-32 x 1/4 inch screws as
shown in Figure 9. Note that drives can be mounted so that the bezel is exposed
(i.e. front-loading drives), or they can be mounted so that the drive bezel is
behind the DS90 filler panel. Use the forward mounting holes to expose a drive's
bezel, and use the rearward holes to mount a drive behind the DS90 filler panel.
Don't tighten the screws yet if exposing the bezel.
NOTE: 3.5 inch front-loading drives will require Kingston adapter brackets for
installation into DS90 models. 3.5 inch hard drives can be bottom mounted
to the existing bracket. Refer to Appendix B for additional information.
Use Front Mounting Holes
for 5.25 inch Front-Loading
Devices or other Devices
that will retain their Front
Bezel
Use Rear Mounting
Holes for 5.25 inch
Internal Devices that
will have their Bezel
Removed
Front of
Device
0276
These Mounting Holes (4 plcs.)
May be Used for 3.5 Inch Hard
Drives