StorCase Technology DS90 - Manual (Page 11)

Installation 5
DS90 User's Guide - Rev. C00 Kingston Technology Company
DATA SILO INSTALLATION
Installing the Drive into the Data Silo
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive. A flat screwdriver and a #2 Philips screwdriver will be required for this procedure.
Removing the DS90 Cover
WARNING: Disconnect all power to the unit before opening the chassis. The DS90
contains NO SERVICEABLE PARTS inside the unit.
The DS90 Data Silo cover is held in place by two (2) tabs located on the back panel.
1. Unplug the Data Silo and verify that all cables have been disconnected.
2. Carefully pry the rear of the cover up on the DS90 by applying slight pressure with
a flat blade screwdriver in the cover release slots (located in two places) on the
DS90 rear panel as shown in Figure 4.
3. Lift the rear of the cover gently and slide it back and off the chassis.
4. Set the cover aside for reinstallation later.
Data
Silo
0215
Figure 4: Removing the Cover