StorCase Technology DS90 - Manual (Page 14)

8 Installation
Kingston Technology Company DS90 User's Guide - Rev. C00
Signal Row
Black (ID0)
Brown (ID1)
Red (ID2)
Black (GND)
GND Row
ID Select Cable (2MM) from
Data Silo ID Select Connector
0
1
2
)
IF INSTALLING AN 8-BIT SCSI DEVICE:
The unit ID cable contains black, brown, and red/black wires. Attach three (3) connectors
from the SCSI ID select cable to the appropriate 2mm drive pins (Figure 6).
The single black wire plugs into the drive pin used to select ID0, the brown wire plugs into
the drive pin for ID1, the red/black wire plugs into the drive pin for ID2.
In most cases, the drive manufacturer labels
each pair of SCSI ID select pins in significant
bit order (0, 1 and 2). One row of drive pins
is the signal row, and one row is designated
for ground. Refer to the drive manufacturer's
documentation for specific pin configurations.
The Data Silo ID select cable provides 2mm,
2-conductor drive connectors. A single wire
Figure 6: 8-Bit Device SCSI ID
Cable Connection
attaches to one side of each connector (with
the exception of the red/black connector).
The cable side of each connector must align
with the signal pin on the drive. On the red/
black connector, the red wire aligns with the
signal pin on the drive and the black wire
aligns with the ground pin.
Signal Row
Black (ID0)
Brown (ID1)
Red (ID2)
Orange (ID3)
Black (GND)
GND Row
0
1
2
3
)
ID Select Cable (2MM) from
Data Silo ID Select Connector
Figure 7: 16-Bit Device SCSI ID
Cable Connection
IF INSTALLING A 16-BIT SCSI DEVICE:
The unit ID cable contains black, brown, red/black, and orange wires. Attach four (4)
connectors from the SCSI ID select cable to the appropriate 2mm drive pins (Figure 7).
The single black wire plugs into the drive pin used to select ID0, the brown wire plugs
into the drive pin for ID1, the red/black wire plugs into the drive pin for ID2 and the
orange wire plugs into the drive pin to select
ID3.
In most cases, the drive manufacturer labels
each pair of SCSI ID select pins in signifi-
cant bit order (0, 1, 2, and 3). One row of
drive pins is the signal row, and one row is
designated for ground. Refer to the drive
manufacturer's documentation for specific
pin configurations.
The Data Silo ID select cable provides 2mm,
2-conductor drive connectors. A single wire
attaches to one side of each connector (with
the exception of the red/black connector).
The cable side of each connector must align
with the signal pin on the drive. On the red/
black connector, the red wire aligns with the
signal pin on the drive and the black wire
aligns with the ground pin.