StorCase Technology DS90 - Manual (Page 15)

Installation 9
DS90 User's Guide - Rev. C00 Kingston Technology Company
Drive Installation
1. Remove the drive bracket from the DS90 as shown in Figure 8.
• Remove the ground wire if it is already attached to the bracket using a
Phillips screwdriver.
• Push down on the release button, located directly behind the bracket.
• While holding the button down, slide the bracket towards the rear of the
chassis and lift the bracket out.
Figure 8: Removing the Drive Mounting Bracket from the DS90 Chassis
PUSH
2
3
0216
Remove
Ground Wire
(if attached) 1
View from Rear of DS90