StorCase Technology S20A120 - Manual (Page 14)

S20A120 User's Guide - Rev. A01 StorCase Technology, Inc.
Installation 7
INSTALLATION
Installing the Drive into the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel,
remove it.
3. SCSI Drive Termination: The DE300 does not provide onboard termination.
External termination must be provided. Refer to the documentation provided by
the drive manufacturer for termination information.
4. ID Select Jumpers: Locate the ID select jumper positions on the drive, and
remove any jumper plugs in this area (the S20A120 drive carrier board will plug
into this section of the drive).
Installation
1. Carefully insert the drive into the carrier. Slide the drive towards the Drive
Carrier Board, so that the I/O, DC power, and ID select connectors on the drive
mate with their respective connectors on the drive carrier board (Figure 6).
NOTE: The S20A120 carrier supports most 68-pin SCSI Ultra160 interfaces, except
Fujitsu Alegro6 10K RPM drives (these drives have different spacing between
the 68-pin and DC power connectors and will not mate with the drive carrier
board).
2. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. screws (Figure
6).