StorCase Technology DE200i-SWU2 - Manual (Page 31)

24 Appendix C - Attaching/Removing the ON/OFF Key
StorCase Technology Inc. DE200i-SWU2 User's Guide - Rev. A00
The DE200 comes from the factory with a power/lock key which is attached to the
locking mechanism. This key can be reconfigured by the user to be removable. To
reconfigure, follow the steps below.
1. Make certain power is OFF to the receiving
frame.
Locate the rectangular shaped key lock
mechanism access hole on the inside of the
receiving frame. Note that the pawl is in an
upright position.
Insert the key into the key lock (skip this step
if key is already fixed to the lock).
2. Rotate the key 90 degrees counterclockwise
so that the pawl is visible in the access hole
as shown in the figure at left.
3. Using the provided alignment tool, unscrew
and remove the pawl from the access hole.
4. Rotate the key 180 degrees clockwise.
5. Reinstall the pawl into the access hole with
the alignment tool.
The key lock has now been reconfigured.
Figure C-1: Reconfiguring the Key Lock Mechanism
Appendix C - Attaching/Removing the ON/OFF
Key