StorCase Technology DE200i-SWU2 - Manual (Page 19)

StorCase Technology Inc. DE200i-SWU2 User's Guide - Rev. A00
12 Installation
IMPORTANT NOTE: In order to use remote ID selection from a computer or
expansion chassis, the Unit ID number on the DE200i-SWU2
receiving frame must be set to "0" with the provided
alignment tool. Refer to the section "Selecting the Unit ID
Number" later in this manual for the Unit ID selection
procedure.
4. With the drive carrier locked in place inside the receiving frame, install the
DE200i-SWU2 into the 5.25” drive opening in the computer or expansion
chassis. Use the appropriate guides to position the DE200i-SWU2, and
fasten it into place with the four (4) #6-32 x 1/4” screws provided. Figure 9
illustrates the location of the mounting holes. Mounting holes are provided
on each side and the bottom of the receiving frame to accommodate a
variety of mounting configurations. Use the mounting holes which best suit
the computer or expansion chassis configuration.
Figure 9: Receiving Frame Mounting Holes
5. Adjust the front of the receiving frame so the carrier slides freely in and out
on the receiving frame guides. The position of adjoining peripheral units may
require adjustment.
6. To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to the receiving frame
motherboard as shown in Figure 5. Connect W1 Pins 9 and 10 to a remote
activity LED.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin
1 indicator on the cable must be properly aligned. Refer to Figure 5 for the
correct Pin 1 location.
NOTE: No onboard termination is provided on the DE200i-SWU2.
External termination must be provided.