StorCase Technology DE200i-SWU2 - Manual (Page 20)

DE200i-SWU2 User's Guide - Rev. A00 StorCase Technology Inc.
Installation 13
8. Connect the power cable from the DC power supply in the computer or
expansion chassis to the power connector on the DE200i-SWU2 receiving
frame. Refer to Figure 5 for the receiving frame power connector location.
9. Replace any expansion boards that may have been removed earlier.
Replace the system cover according to the manufacturer’s instructions.
10. Reconnect any system or peripheral cables removed earlier.
11. Turn on power to the computer. If the installation has been successful, and
all cables have been properly attached, the system should boot normally.
Although the computer may not recognize the DE200i-SWU2 yet, the
appropriate front panel LED indicators on the Data Express should illuminate.
NOTE: The lock on the DE200i-SWU2 receiving frame functions as a
lock and a DC power switch for the carrier unit. The lock must
be engaged (turned counterclockwise) in order to supply power
to the carrier and installed drive unit.
12. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or com-
puter manufacturer's documentation for formatting information.
Selecting the Unit ID Number
1. Verify that power is turned on to the DE200i-SWU2 receiving frame by
turning on the computer or external expansion chassis. A number should
appear in the unit display window if the carrier is locked in place.
2. Unlock the DE200i-SWU2 drive carrier and remove it from the receiving
frame. A "u" will be displayed initially when the unit is unlocked but will
return to a number when the carrier is removed from the receiving frame.
WARNING: Unlocking the carrier unit switches DC power off to the
drive. Since disk drives require a short amount of time to
spin down, allow about 15 seconds before pulling the
carrier unit out of the receiving frame to avoid possible
damage to the drive.
3. Use the alignment tool supplied with the DE200i-SWU2 to select the ID
number of the disk drive. Refer to Figure 10 for the location of the ID
Select Switch inside the receiving frame.
4. After selecting an appropriate unit ID number, replace the DE200i-SWU2
carrier in the receiving frame, and LOCK IT IN PLACE.