StorCase Technology DE100i-SWU2 - Manual (Page 31)

24 Appendix C - Attaching the On/Off Key
Kingston Technology Company DE100i-SWU2 User's Guide - Rev. A00
The following information will provide the necessary steps to attach the On/Off key to the
key/lock mechanism so that it is non-removable, preventing accidental key loss. The
procedure can be reversed if, at a later date, you want to remove the key.
1. Make certain power is off to the receiving
frame.
Locate the rectangular shaped key/lock
mechanism access hole on the inside of the
receiving frame. Note that the pawl is in an
upright position.
Insert the key into the key/lock.
2. Rotate the key 90 degrees counter-clockwise
so that the pawl is visible in the access hole as
shown in the figure at left.
3. Using the provided alignment tool, unscrew
and remove the pawl from the access hole.
4. Rotate the key 180 degrees clockwise.
5. Reinstall the pawl into the access hole with the
alignment tool.
Your key is now attached to the key/lock
mechanism.
0156
Pawl
Access
Hole
Key/Lock
90
Degrees
180
Degrees
Appendix C - Attaching the On/Off Key
to Non-Solenoid Units
Figure C-1: Attaching the On/Off Key