StorCase Technology DE100i-SWU2 User Manual
Page 19
Kingston Technology Company
DE100i-SWU2 User's Guide - Rev. A00
12
Installation
Mounting
Holes (Right)
Mounting
Holes (Bottom)
Front of Unit
Mounting
Holes (Left)
0086
IMPORTANT NOTE: In order to use remote ID selection from a computer or
expansion chassis, the Unit ID number on the Data Express
receiving frame must be set to '0' with the provided alignment
tool. Refer to the section "Selecting the Unit Number" later in
this manual for the Unit ID selection procedure.
4.
With the drive carrier locked in place inside the receiving frame, install the
Data Express into the 5.25 drive opening in the computer or expansion
chassis. Use the appropriate guides to position the Data Express, and fasten
it into place with the four (4) #6-32 x 1/4 screws provided. Figure 9
illustrates the location of the mounting holes. Mounting holes are provided on
each side and the bottom of the receiving frame to accommodate a variety of
mounting configurations. Use the mounting holes which best suit the
computer or expansion chassis configuration.
Figure 9: Receiving Frame Mounting Holes
5.
Adjust the front of the receiving frame so the carrier slides freely in and out
on the receiving frame guides. The position of adjoining peripheral units may
require adjustment.
6.
To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to the receiving frame
motherboard as shown in Figure 5. Connect W1 Pins 9 and 10 to a remote
activity LED.
7.
Connect the I/O interface cable from the host adapter to the receiving frame.
The Pin 1 indicator on the cable must be properly aligned. Refer to Figure 5
for the correct Pin 1 location.
NOTE:
No onboard termination is provided on the DE100i-SWU2.
External termination must be provided.