StorCase Technology DE100i-SWU2 - Manual (Page 17)

Kingston Technology Company DE100i-SWU2 User's Guide - Rev. A00
10 Installation
Installing the Receiving Frame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver during this procedure.
1. Turn off power to the computer.
2. Open the computer system according to the manufacturer’s instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3. To select the Data Express unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
connected to the Option Pin Connector (W1) on the rear of the receiving frame
as shown in Table 2 and Figure 8.
1 ID0 SCSI ID
2 GND Ground
3 ID1 SCSI ID
4 GND Ground
5 ID2 SCSI ID
6 GND Ground
7 ID3 SCSI ID
8 GND Ground
9 RLEDC Remote LED Cathode
10 RLEDA Remote LED Anode
11 Reserved
12 Reserved
13 Reserved
14 Reserved
15 Reserved
16 Reserved
17 Reserved
18 Reserved
19 Reserved
20 Reserved
21 Reserved
22 Reserved
PIN Signal Function
Table 2: Option Pin Connector (W1) Signal Descriptions