StorCase Technology DE100i-SWU2 - Manual (Page 15)

Kingston Technology Company DE100i-SWU2 User's Guide - Rev. A00
8 Installation
Installation
1. Attach the I/O interface cable from the rear distribution board of the Data
Express carrier to the disk drive (Figure 6).
2. Attach the four-pin disk power cable from the rear distribution board to the
disk drive (Figure 6).
3. Install the five-pin ID select cable into the rear signal distribution board
connector. Refer to Figure 7 for a typical 2mm drive pin connection.
4. Carefully insert the drive into the carrier at an angle, cable-end first. Make
sure that none of the cables are pinched. Lower the front of the drive
carefully into place. Fasten the drive into the carrier with four (4) #6-32 x
3/16" Flat Head screws provided.
5. Attach the provided cable cover with two (2) #6-32 x 3/16" Flat Head
screws provided.
Figure 6: Drive Installation Assembly
Drive Carrier
Disk Drive
Power Cable
I/O Interface
Cable/s
Drive Mounting
Hardware (4ea)
Phillips # 6-32 x
3/16 Flat HD
ID Select Cable
(Typical)
0151
Cable
Cover
(Provided)
Cable Cover
Screws (2 plcs)
# 6-32 x 3/16
Flat HD
Standoff (4 Plcs).
Can only be used
on low profile 1"
high drives. Use
only if additional
connector space is
required below drive.