StorCase Technology DE75i-A66 - Manual (Page 18)

DE75i-A66 User's Guide - Rev. A00 StorCase Technology Inc.
Installation 11
Figure 9: Receiving Frame Mounting Holes
5. Adjust the front of the receiving frame so the carrier slides freely in and out
on the receiving frame guides. The position of adjoining peripheral units may
require adjustment.
6. To connect the drive to a Remote Activity LED in the computer system,
connect the appropriate cable(s) to the receiving frame rear panel as shown
in Figure 4. Connect JP6 Pins 17 and 18 to a remote activity LED.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1
indicator on the cable must be properly aligned. Refer to Figure 4 for the
correct Pin 1 location.
8. Connect the power cable from the DC power supply in the computer chassis
to the power connector on the DE75i-A66 receiving frame. Refer to Figure 4
for the receiving frame power connector location.
9. Replace any expansion boards that may have been removed earlier. Replace
the system cover according to the manufacturer’s instructions.
10. Reconnect any system or peripheral cables removed earlier.
11. Turn on power to the computer. If the installation has been successful, and
all cables have been properly attached, the system should boot normally.
Although the computer may not recognize the DE75i-A66 yet, the front panel
display on the Data Express should illuminate.
NOTE: The lock on the DE75i-A66 receiving frame functions as a lock and a DC
power switch for the carrier unit. The lock must be engaged (turned
counterclockwise) in order to supply power to the carrier and installed
drive unit.
12. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or
computer manufacturer's documentation for formatting information.