beautypg.com

De75i-a66 installation, Installing the drive into the carrier preparation – StorCase Technology DE75i-A66 User Manual

Page 13

background image

6

Installation

StorCase Technology Inc.

DE75i-A66 User's Guide - Rev. A00

DE75i-A66 INSTALLATION

Installing the Drive into the Carrier

Preparation

While performing the steps in this section, work on a soft surface to prevent excessive

shock to the drive being installed. Also refer to the manufacturer's documentation

provided with the drive.

NOTE:

A #2 Phillips screwdriver will be required during this procedure.

1. Remove the drive from its protective packaging.

2. Plastic Drive Bezel: If the drive came equipped with a plastic front panel

(bezel), it must be removed before installing the drive into the drive carrier.

3. Master/Slave Drive Selection: There are two ways to set the Master/Slave

drive designation for the DE75i-A66 unit:
•

Method 1: Use the factory-installed jumper on your IDE drive - In

most cases, the drive will be factory-configured as a Master Ultra ATA/66 drive

using a jumper plug on the drive itself. No configuration changes are required.

For multiple drive configurations, it is necessary to set the first IDE drive as

Master and the second Ultra ATA/66 drive to Slave. This can be done by

changing the jumper on the Ultra ATA/66 drive itself (refer to your drive

manufacturer documentation). This method requires no additional configuration

of the drive carrier circuit board. Skip the Method 2 section below and

continue with the "Installation" section.

•

Method 2: Use the hard-wire connector JP3 and/or JP4 on the drive

carrier circuit board - The Master/Slave drive selection is set by both a hard-

wire connection between the drive and the drive carrier circuit board and

jumper(s) JP4 configuration on the receiving frame motherboard. This method

requires the fabrication of a cable wire (not provided). Refer to the section

below to configure the drive carrier circuit board and receiving frame

using this method.

Configuring the Drive Carrier Circuit Board (Method 2)

When configuring the dual drives for interchangeable Master/Slave assignment, it is

necessary to emulate the Master and Slave drive jumpers and the specific drive's signal

polarity definition of Master and Slave.

NOTE:

For dual, interchangeable drive configuration, the two drives must be

of the same make and model.