Speck Electronics MicPre 5.0 - Manual (Page 16)

Connecting the MP 5.0
to the Model ASC EQ
With only a few simple connections, the MP 5.0 can be combined with
the Speck Electronics "Model ASC" 4 band equalizer to form a single
channel strip.
The following illustration shows how to interface the ASC equalizer to
the insert send/return jacks of the MP5.0 and how to power the ASC
from the Aux DC power source of the MP 5.0.
If you use the optional ASC-DCI cable, do not use the ASC power
module for the installation.
Connect one end of the ASC-DCI interface cable (green mark - face up)
to the connection marked “Aux DC Out” on the MP5.0. Connect the
other end of the interface cable (green mark - face up) to the connection
marked “Aux DC I/O” on the ASC. The plugs and respective connectors
are keyed so they will fit in only one direction.
USE WITH SPECK
PRODUCTS ONLY
OUTPUT INPUT speck
electronics
Model ASC - 4 Band Equalizer
OUTPUT TRANSFORMER OPTION
Fallbrook, California
S/N
POWER AUX DC I/O
USE WITH PS -4
POWER MODULE
LIFT
BAL. XLR BAL. ¼ UNBAL.¼
HIGH
GND
LOW
PIN 2
PIN 3
PIN 1 TIP
RING
SLEEVE
TIP
SLEEVE
GND
Chapter 2 Installation Section 10
DIRECT OUTPUT INPUT MIX LINK
speck
electronics
S/N
230V (.1A)
MIX LEFT
INSERT RTN
PRE OUT-B
INSERT SEND
LINE IN
AUX DC OUT
CAUTION
MicPre 5.0
115V (.2A)
MIX RIGHT
O.S.P.
OR
RISK OF ELECTRICAL SHOCK - DO NOT
OPEN OR EXPOSE TO RAIN OR MOISTURE.
NORMAL
Do not connect
the ASC
power module
ASC-DCI cable