Roubleshooting – Southbend SL-Series User Manual
Page 35
E
LECTRIC
C
ONVECTION
O
VENS
OPERATOR’S MANUAL 1181958 REV 5 (4/14)
PAGE
35
OF47
CONTROL PANEL ACCESS AND SHUT-OFF SWITCH
To access the control panel components, remove the remove the two thumbs screws at the top and bottom of the control
panel and slide the control panel out (see 1ST picture). A wiring diagram for the oven is located on the side of the control
panel assembly
When the control panel is slid out, all power to the control panel is cut off by a shut down switch
that is located directly inside the opening and below the control panel (see 2ND picture). To re-energize the controls
for troubleshooting, pull the white plunger on the shut down switch up.
To fully remove Control Panel, disconnect temp probe wires and harness connectors prior to pulling up on slide release
levers and removing.
T
ROUBLESHOOTING
Accessing Control Panel
Components
Accessing Control Panel
Components