Southbend KTLG-20 - Manual

Job Item#
www.yatesgd.com www.yatesgraphicdesign.com Form KTLG Rev 2 (November/2010)
G
as
s
team
t
iltinG
K
ettle
SPECIFICATIONS:
Shall be a Southbend Model ___________________________,
self-contained, gas fired, fully insulated steam jacketed kettle,
ASME Code stamped, National Board Registered, AGA, CGA
and NSF certified for operation up to 50 PSI. A double wall
interior shall form a steam jacket around the lower 2/3 of the
kettle. The jacket enclosure shall contain factory sealed, distilled
water. The kettle interior on models 20, 30 and 40 gallon models
shall be stainless stell, type 316 for high acid content cooking.
The kettle interior on 60 gallon models shall be type 304 stainless
steel. Kettle exterior is fully insulated. The bottom of the kettle
shall be of hemispherical design for superior heat circulation.
The recessed control panel is located on the front right of the
unit, in full view of the operator and easy to use. Standard
controls include direct immersion thermostat for operation at a
temperature range of 165°F to 275°F (74°C to 135°C) at 50 psi,
water sight glass, cooking light, pressure gauge and electronic
ignition with ignition indicator light. Safety features include low
water shut off with indicator light, pressure switch, pressure relief
valve and a 100% safety gas shut off valve.
The kettle shall pivot on trunnions connected to the tilt
mechanism and control consoles. The tilt mechanism shall allow
the kettle to tilt past 90° for complete emptying. The console
shall be drip proof, stainless steel clad and shall be supported
on all welded, 1-5/8” (41 mm) diameter stainless steel legs with
flanged feet for securing to the floor.
OPERATION SHALL BE BY:
High efficiency power burner system for operation on 115
VAC, 1 Phase, 50/60 Hz.

Natural gas
 L.P. gas
OPTIONAL ITEMS AT EXTRA COST:

Type 316 stainless steel liner (for KTLG-60 only)
 208-240 VAC operation (specify voltage)
 Spring assist stainless steel cover (CH-)
 2" (50 mm) tangent draw-off valve (TVT-2)
 3" (76 mm) tangent draw-off valve (TVT-3)
 2” (50 mm) dairy draw-off valve (DDO-2T)
 3” (76 mm) dairy draw-off valve (DDO-3T)
 Etched gallon markings (GM-)
 Etched litre markings (LM-)
 Single pantry faucet with swing spout (SF-18)
 Double pantry faucet with swing spout (DF-18)
 Casters
 Correctional package
ACCESSORIES:

Triple basket assembly (TBA-)
 Graduated measuring strip (CMS-)
 Perforated strainer for draw-off valve (TPS-)
 Solid stainless steel disc for draw off (TSS-)
 Strainer hook (SH-)
 Pour strainer (TKS-)
 Pan carrier
 Draw-off valve hose kit (DVHK-)
Shown with optional spring
assist cover and faucet
M
odel
C
apaCity
KTLG-20 20 Gallon 76 Liter
KTLG-30 30 Gallon 114 Liter
KTLG-40 40 Gallon 152 Liter
KTLG-60 60 Gallon 227 Liter