Dynex DX-LDVD19-10A - Manual (Page 8)

4
TV components DX-LDVD19-10A
Make sure that you handle your TV very carefully when attempting
removal of the stand. If you are not sure of your ability to do this, or to
use the tools necessary to complete this job, refer to a professional
installer or service personnel. The manufacturer is not responsible for
any damages or injuries that occur due to mishandling or improper
assembly.
When using a table or bench as an aid to assembly, make sure that you
place the TV on a soft cushion or covering to prevent accidental
scratching or damage to your TV’s finish.
The speaker is not intended to support the weight of your TV. Do not move
or handle your TV by the speaker. This can cause damage to your TV
that is not covered by the manufacturer’s warranty.
Removing the stand
To remove the stand from the stand column:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Adjust the stand so that the angle between the stand and the TV
is 90°.
3 Remove the two (2) M4 screws that secure your TV to the stand,
then pull the stand off the TV.
Installing a wall-mount bracket
If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand.
To attach your TV to a wall-mount bracket:
Warning: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of hazards, do not perform any
servicing other than that contained in the operating instructions
unless you are qualified to do so.
• Secure the wall-mount bracket to the back of your TV using the
four M4 screws provided with the bracket.
TV components
Front and side panels
Remove screws
# Component Description
1 MENU Press to open the on-screen menu.
2 INPUT Press to select the video input source.
3 VOL+/VOL- Press to increase or decrease the volume.
4 CH+/CH- Press to go to the next or previous channel
in the channel list.
5 POWER button Press to turn on your TV. Press again to put
your TV in standby mode.
6 Power indicator Lights blue when your TV is turned on.
Lights red when your TV is in standby mode.
Not lit when the power cord is unplugged.
7 Remote sensor Receives signals from the remote control. Do
not block.
VOL VOL CH CH POWER MENU INPUT + - + -
DX-LDVD19-10A_09-0340.book Page 4 Tuesday, April 28, 2009 4:43 PM