SkyRC SKYRC1000W Charger - Manual (Page 19)

17 · Ultimate 1000W
SYSTEM SETTING
S a f e t y T i m e r
O N 1 2 0 M i n
R e s t T i m e
C H G > D C H G 1 0 M i n
C a p a c i t y C u t - O f f
O N 5 0 0 0 m A H
This program sets the maximum charge
capacity that will be supplied to the battery
during charge. If the delta peak voltage is
not detected nor the safety timer expired by
any reason, this feature will automatically
stop the process at the selected capacity
value.
When you start a charge process, the
integral safety timer automatically starts
running at the same time. This is
programmed to prevent overcharge the
battery if it proves to be faulty, or if the
termination circuit cannot detect the battery
full. The value for the safety timer should be
generous enough to allow a full charge of
the battery.
OFF/
ON
(
100-50000 mAh)
It is essential for users to do system settings before use. After entering system setting
program, the screen displays the following information in sequence and the user can
change the value of parameter on each screen.
When you are willing to alter the parameter value in the program, press START/ENTER to
make it blink then change the value with INC or DEC. The value will be stored by
pressing START/ENTER once.
ITEM SELECTION DESCRIPTION
OFF/
ON
(
1-720 Min )
1-60Min
A rest time allowing the battery to cool
down between charging/discharging cycle.
K e y B e e p O N
B u z z e r O N
OFF/ON
The beep sounds at every time touching
the buttons to confirm your action. The
beep or melody sounded at various times
during operation to alert different mode
changes.
P o w e r S o u r c e ?
D C P o w e r S u p p l y
DC Power Supply/
Battery
Choose the power source.