页 13, Operating program – SkyRC SKYRC1000W Charger User Manual
Page 13
11 ·
Ultimate 1000W
Important Notice
To take advantage of Ultimate 1000W’s full power capability, the power
source should be 30V DC, and output power should be capable of 1200W
or higher.
Low quality DC power source may damage your Ultimate 1000W charger.
We recommend you to choose EFUEL 1200W Power Supply.
Connecting to Battery supply
If you use the battery as the power source, please do set the right battery current and cut
voltage, or it will get damage to the charger and the charging battery.
Failure to connect as shown in this diagram will damage this charger.
To avoid short circuit between the charge lead always connect the charge cable to the
charger first, then connect the battery. Reverse the sequence when disconnecting.
WARNING:
Connecting the battery
Important!!! Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly. If the settings are incorrect, the battery may
be damaged, and could even burst into flames or explode. To avoid short circuits
between the banana plugs, always connect the charge leads to the charger first, and only
then to the battery. Reverse the sequence when disconnecting the pack.
Balance Socket
The balance wire attached to the battery must
be connected to the charger with the black wire
aligned with the negative marking. Take care to
maintain correct polarity! (See the wiring
diagram below.)
This diagram shows the correct way to connect
your battery to the SKYRC Ultimate 1000W
while charging in the balance charge program
mode.
2).
3).
OPERATING PROGRAM
It is a MUST for charging Lithium (LiPo, Lilo, LiFe and LiHV) battery in
Charge, Fast Charge, Balance Charge and Storage mode. If you don't
connect the battery to the balance socket while the charger is working in
mentioned modes, the charger won't start working.
Balance Port Charging
If you charge the battery with the balance port, first, connect the balance
board to the charger, and then connect the battery balance wire to the
balance board.