SkyRC SKYRC1000W Charger - Manual (Page 12)

OPERATING PROGRAM
Here is the detailed procedure to make the charger work. All the screens and operations
will take Li-Po BALANCE CHARGE program for example,
1. Connection
Connecting to power source 1).
· 10 Ultimate 1000W
There are 2 kinds of power source: DC power supply and Lead Acid battery. After
you connect the power source to the charger, when you power up the charger for
the first time or load the factory default setting, please follow below steps,
P o w e r S u p p l y ?
> D C P o w e r S u p p l y
DEC INC
P o w e r S o u r c e
> B a t t e r y
B a t . S u p p l y : 3 0 . 0 A
C u t V o l t . : 1 1 . 0 V
D C S u p p l y :
C u t V o l t . : 1 1 . 0 V 3 0 . 0 A ENTER
ENTER
D C S u p p l y :
C u t V o l t . : 1 1 . 0 V 3 0 . 0 A ENTER
DEC INC
B a t . S u p p l y : 3 0 . 0 A
C u t V o l t . : 1 1 . 0 V
ENTER
DEC INC
Press the START/ENTER button to make the current value blink then change the
value by pressing DEC and INC button. The value will be stored by re-pressing the
START/ENTER button. At the same time cut voltage will start to blink, press DEC
and INC button to change the value and repress START/ENTER button to store it.
4mm Bullet
Connectors
plugging
to eFUEL power
supply directly
Ultimate 1000W comes with male 4mm Bullet connectors attached to the power
INPUT cables. These cables are appropriate for attaching directly to most high-
quality AC-DC power supply units, such as EFUEL 1200W Power supply.
Make sure to choose the right power source and set up the right current
and cut voltage.
The charger will save the setting for next use if you don’t change it. So if
you change the power source, please make sure to change the setting in
the charger. Note1:
Note2:
Connecting to DC power supply