SkyRC SKYRC1000W Charger - Manual (Page 16)

· 14 Ultimate 1000W
OPERATING PROGRAM
8. Program Stop
9. Program Complete
During the charging process, press STOP to stop the charging process.
When the charging process finishes, an audible sound will be heard.
Charging Program
Depends on different battery type, the operation programs are different.
NiMH
NiCd
RE-PEAK
CYCLE
Pb
Batt
Type Operation
Program
Description
This charging mode is for charging LiPo/LiFe/LiIon/LiHV battery in normal mode.
This program is for charging or discharging lithium battery which will
not be used for long time.
The charging capacity may be a bit smaller than normal charging but
the process time will be reduced.
This mode is for balancing the voltage of lithium-polymer battery cells
while charging.
The charger will charge NiMH and NiCd batteries using the charge
current set by the user.
In this program the charger detects the condition of the battery which
is connected to the output and automatically charges the battery.
Note: you should set up the upper limit of the charge current to
avoid damage by excessive feeding current. Some batteries of
low resistance and capacity can lead to higher current.
In re-peak charge mode, the charger can peak charge the battery
once, twice or three times in a row automatically. This is good for
confirming the battery is fully charged, and for checking how well the
battery receives fast charges.
1 to 5 cyclic and continuous process of charge>discharge or
discharge>charge is operable for battery refreshing and balancing to
stimulate the battery's activity.
LiPo
Lilon
LiFe
LiHV
CHARGE
REGENERATIVE
DISCHARGE*
STORAGE
FAST CHG
BAL CHARGE
CHARGE
AUTO CHG
DISCHARGE
CHARGE
DISCHARGE
This mode is for discharging LiPo/LiFe/LiIon battery when the
power source is Lead Acid battery.
/LiHV
This mode is for discharging NiMH/NiCd battery.
This mode is for charging Pb battery.
This mode is for discharging Pb battery.
MICRO CHARGE
MICRO STORAGE
This mode is for balancing the voltage of lithium-polymer battery cells
while charging with balance port.
This program is for charging or discharging lithium battery which will
not be used for long time with balance port.
DISCHARGE This mode is for discharging LiPo/LiFe/LiIon battery. /LiHV
REGENERATIVE
DISCHARGE* This mode is for discharging NiMH/NiCd battery
source is Lead Acid battery. when the power
REGENERATIVE
DISCHARGE* This mode is for discharging Pb battery
Lead Acid battery. when the power source is