页 16, Motor rpm tester, Servo tester – SkyRC 6x80+ Blue Version Charger User Manual

Page 16

MOTOR RPM TESTER

The charger can test motor RPM. Please do as follows,

Connect the motor and ESC.
Switch off the ESC and connect it to the battery.
Connect the power to the charger.
Insert the ESC signal wire to ESC port in the charger.
Connect the motor and charger with motor sensor wire. There is a motor
sensor port beside the temp sensor.
Enter Motor RPM Tester Program, set the initial pulse width which should be
the same as the neutral position of the transmitter. We suggest to set it to 1480
as most of the transmitters’ neutral position is like that.
Switch on the ESC. Change the pulse width and check the RPM corresponding
to different pulse width. If the motor doesn’t run, please recheck the transmitters’
neutral position and reset the initial pulse width.

Press the Start/Enter dial to enter the Motor RPM Tester
Program and set the initial pulse width by rotating the
Start/Enter knob.
Switch on the ESC.

The left side of the first line shows the pulse width and
the second line shows the RPM of the motor
corresponding to different pulse width. The value of
pulse width can be changed by rotating the Start/Enter
dial.

1.
2.
3.
4.
5.

PROGRAM

SELECT

MOTOR

RPM TESTER

SELECT

PULSE WIDTH:1500
RPM: 00000

SELECT

This diagram shows the
correct connect way to
test motor RPM.

6X80 Plus

SERVO TESTER

The charger can check whether the servo works. Please do as follows,

Connect the battery to the power.
Connect the servo to the servo port in left side of the charger. Be
careful with the correct polarity.
Enter to Servo Tester Program in the charger, change the pulse
width and check the response of the servo.

1.
2.

Press the Start/Enter dial to enter the Servo
Tester Program.

The screen displays the pulse width. Rotate the
Start/Enter dial to change the value of pulse
width and observe the response of the servo
corresponding to different pulse width

PROGRAM

SELECT

SERVO TESTER

SELECT

PULSE WIDTH:

900uS

SELECT

This diagram shows the correct connect way to test the servo.