RAVE Sports Slidewalk - Manual (Page 8)

7
inflated. Check alignment of tubes and fit of cover
periodically during inflation. If tubes are not aligned
properly, release some air and move tubes to align.
When properly inflated and assembled, the tubes
on the underside of the Aqua Slide should be level
with each other and the cover should be straight
and taught as shown.
Connecting to your Water Trampoline
To attach Slide to Classic Aqua Jump™ (with steel frame), see p. 7
To attach Slide to Aqua Jump™ Eclipse (without steel frame), see p. 8
To attach Slide to Aqua Deck™, see p. 10
To attach Slide to Bongo™, see p. 10
Attaching the Aqua Slide to Classic Aqua Jump™
(Models AJ10, AJ15, AJ20, AJ25, with steel trampoline frame)
Step 3
Determine the preferred location for the Slide on the
Aqua Jump. Wrap the two straps around the inflated
tube near each inside corner of the desired panel
location. Properly positioned, both attachment straps
for the Slide will be on the same colored
panel and running parallel with each other
on the Aqua Jump tube.
IMPORTANT: Rotate the strap around the
tube until the buckle is located just
below the bar towards the inside of the
tube. Insert the end of the strap into the
Buckle