Safety rules and information, Inflation valve operation, Assembling your slide – RAVE Sports Slidewalk User Manual
Page 7: Assembling your log, Assembling your launch, Assembling your slidewalk, Cleaning and storage, Repairs
6
C A U T I O N
DO NOT USE AN AIR COMPRESSOR TO INFLATE ANY AQUA
ATTACHMENT. USE OF AN AIR COMPRESSOR MAY CAUSE OVER-
INFLATION, WHICH CAN DAMAGE OR RUPTURE SEAMS.
IMPORTANT:
It is normal for the air pressure within air filled tubes to
fluctuate depending on air and water temperatures. It may be
necessary to increase or decrease the air pressure in your
product accordingly. To avoid damage on extremely hot days it
may be necessary to check and release the air pressure from
your product throughout the day.
AQUA SLIDE ASSEMBLY INSTRUCTIONS
Aqua Slide™
Step 1
Lay the Slide cover on a flat surface. Make sure
there are no sharp objects under the product that
might puncture the tubes. Both tubes are identical.
Orient the tubes between the straps and the cover
with the tube seams facing upward. Insert so the
long leg of the tube is positioned in the long section
of the cover.
Step 2
Inflate both tubes approximately 50% full. Adjust
tubes so the seams of both tubes are face up and
the ends of the tubes line up with each other and
the cover. Alternate inflating each tube until fully
!!