RAVE Sports Slidewalk - Manual (Page 18)

17
SLIDEWALK ASSEMBLY INSTRUCTIONS
Slidewalk
™
(NOTE: This product assembles and attaches in the same manner
for all RAVE water trampoline products.)
Step 1
Lay the Slidewalk on a flat surface. Make sure there are no sharp
objects under the product that might puncture the tube.
Spread out the cover, with inside facing up, on a flat surface free
from debris and sharp objects. Extend straps away from cover and
place tubes in cover. Position the tubes so the inflation valves are at
the same end and they are facing up.
Step 2
Inflate both tubes to about 75% full. Loosely buckle
all straps leaving slack to allow for full inflation of
the tubes. Ensure cover is evenly positioned over
the tubes and the end flaps are parallel to the
ground.
Rotate and adjust both tubes so the buckles are
facing straight up and the ends of the tubes are
even.
Inflate both tubes to full capacity, making sure
that the tubes are even with each other, the
buckles are facing upward and the cover is
evenly positioned over the tubes.
Tighten all of the cover straps running across the tops of the tubes.