RAVE Sports Slidewalk - Manual (Page 16)

15
AQUA LAUNCH ASSEMBLY INSTRUCTIONS
Aqua Launch™
(NOTE: This product assembles and attaches in the same manner for all RAVE water
trampoline products.)
Step 1
Lay the Aqua Launch on a flat surface. Make sure there are no sharp
objects under the product that might puncture the tube.
Step 2
See inflation and valve operation on p. 5.
Inflate the Launch until the tip of the inflation gauge
strap is just touching the ground. DO NOT FILL THE
LAUNCH TO FULL CAPACITY. A softer Launch will
perform better than a firmer one. You might want
to experiment with air pressure for best launching
results. Use the inflation gauge strap as a reference
as to how much air is in the Launch. More air will
raise the tip of the strap relative to the surface of
the water.
Step 3
Locate the apron and straps on the end of the
Launch. Make sure the RAVE Sports logo on the
other end is in the upright position.
Step 4
It is easiest to attach while both the water
trampoline and Aqua Launch are in shallow water.
The apron flap of the Launch should spread over the top side of the
water trampoline tube. Wrap the apron straps of the Launch over
Tip of strap should
be touching surface
of water.