ParkZone PKZ5180 - Manual (Page 9)

En
1. Put the wing tube in the round hole in the wing slot of the
fuselage.
2. Put left wing on the wing tube.
3. Move the wing on the tube into the slot in the fuselage while
putting the aileron control connector in the fuselage.
4. Fully install left wing in fuselage using screw.
5. Install the right wing using the steps above.
6. Attach the two (2) aileron connectors to the aileron Y-harness
in the fuselage.
Note: There is no difference between the two connections on
the Y-harness. Left and right servo lead connectors do not have
to be connected to a particular side of the Y-harness.
Installing Wings
Tip: Install aileron servo wires in the fuselage’s molded
channels using tape. Tape will keep the wires from blocking
battery installation.
Note: Due to the Z-foam™ construction of the Extra 300, the
wing can flex to absorb flight loads during hard positive
or negative G forces. This is more noticeable during hard
maneuvering, but is normal.
8