General assembly and maintenance tips – ParkZone PKZ5180 User Manual
Page 6
En
Note: This checklist is not a replacement for the content included in this manual. Although it can be used as a quick start guide, we
strongly suggest reading through this manual completely before proceeding.
First Flight Preparation
Activity
PNP BNF
Remove and inspect contents
u
u
Begin charging flight battery
u
u
Assemble Extra 300
u
u
Install receiver
u
Connect servos to receiver or Y-harness
u
u
Install fully charged battery
u
u
Bind the receiver to a transmitter, if applicable
u
u
Perform the Control Direction Test with the transmitter
u
u
Adjust flight controls and transmitter
u
u
Adjust battery for center of gravity (CG) see page 9
u
u
Perform a radio system Range Check
u
u
Find a safe and open flying field
u
u
Plan flight for flying field conditions
u
u
Maintenance After Flying
Activity
PNP BNF
Disconnect flight battery from ESC
(Required for Safety)
u
u
Turn off transmitter
(Required for Safety)
u
u
Remove flight battery from aircraft
u
u
Recharge flight battery
u
u
Clean aircraft (wipe off dirt, etc.)
u
u
Repair or replace all damaged parts
u
u
Carefully disassemble and store aircraft
u
u
Store flight battery apart from aircraft and monitor the battery charge
u
u
Make note of flight conditions and flight plan results, planning for future flights
u
u
General Assembly and Maintenance Tips
5