Mossberg 715T - Manual (Page 18)

TO REASSEMBLE THE FIREARM
Assemble the bolt spring and bolt spring guide rod into the bolt assembly (Fig.
17a and 17b).
Fig. 17a Fig. 17b.
Insert the assembly into the receiver, bolt face first (Fig. 18a). Insert the operat-
ing handle through the ejection port to line up with the operating handle slot in the
bolt (Fig. 18a).
Fig. 18a Fig. 18b
Compress the bolt spring and lower the bolt assembly into the receiver (Fig. 18b).
As the bolt is lowered into the receiver make sure the operating handle does not
move out of position. Compress the bolt recoil spring until the end of the bolt
spring guide pops into the blind hole in the rear of the receiver.
Insert the bolt buffer (Fig. 19). Make sure it is oriented as shown in figure 14.
18
Fig. 19
TO REASSEMBLE THE FIREARM
Assemble the bolt spring and bolt spring guide rod into the bolt assembly (Fig.
17a and 17b).
Fig. 17a Fig. 17b.
Insert the assembly into the receiver, bolt face first (Fig. 18a). Insert the operat-
ing handle through the ejection port to line up with the operating handle slot in the
bolt (Fig. 18a).
Fig. 18a Fig. 18b
Compress the bolt spring and lower the bolt assembly into the receiver (Fig. 18b).
As the bolt is lowered into the receiver make sure the operating handle does not
move out of position. Compress the bolt recoil spring until the end of the bolt
spring guide pops into the blind hole in the rear of the receiver.
Insert the bolt buffer (Fig. 19). Make sure it is oriented as shown in figure 14.
18
Fig. 19
TO REASSEMBLE THE FIREARM
Assemble the bolt spring and bolt spring guide rod into the bolt assembly (Fig.
17a and 17b).
Fig. 17a Fig. 17b.
Insert the assembly into the receiver, bolt face first (Fig. 18a). Insert the operat-
ing handle through the ejection port to line up with the operating handle slot in the
bolt (Fig. 18a).
Fig. 18a Fig. 18b
Compress the bolt spring and lower the bolt assembly into the receiver (Fig. 18b).
As the bolt is lowered into the receiver make sure the operating handle does not
move out of position. Compress the bolt recoil spring until the end of the bolt
spring guide pops into the blind hole in the rear of the receiver.
Insert the bolt buffer (Fig. 19). Make sure it is oriented as shown in figure 14.
18
Fig. 19
TO REASSEMBLE THE FIREARM
Assemble the bolt spring and bolt spring guide rod into the bolt assembly (Fig.
17a and 17b).
Fig. 17a Fig. 17b.
Insert the assembly into the receiver, bolt face first (Fig. 18a). Insert the operat-
ing handle through the ejection port to line up with the operating handle slot in the
bolt (Fig. 18a).
Fig. 18a Fig. 18b
Compress the bolt spring and lower the bolt assembly into the receiver (Fig. 18b).
As the bolt is lowered into the receiver make sure the operating handle does not
move out of position. Compress the bolt recoil spring until the end of the bolt
spring guide pops into the blind hole in the rear of the receiver.
Insert the bolt buffer (Fig. 19). Make sure it is oriented as shown in figure 14.
18
Fig. 19
135055_PN 17925 Rev E.indd 18 1/4/13 9:57 AM