Mossberg 715T - Manual (Page 16)

Fig. 14
Using the operating handle, pull the bolt rearward until you can insert your fore-
finger in front of the bolt. Be careful not to pinch your finger between the bolt face
and the barrel. Lift up slightly on the bolt with your forefinger and remove the bolt
handle through the ejection port.
Fig. 15
Continue to lift up on the bolt while slowly letting it come forward to rest against
the barrel. Reposition your forefinger grip and insert a finger through the ejection
port (Fig. 16). Maneuver the bolt assembly completely up and out of the receiver.
Remove the bolt spring and bolt spring guide rod (Fig. 17a).
Fig. 16
No further disassembly should be done by the owner. If service is required, con-
tact the factory authorized service center or a qualified gunsmith.
16
Fig. 14
Using the operating handle, pull the bolt rearward until you can insert your fore-
finger in front of the bolt. Be careful not to pinch your finger between the bolt face
and the barrel. Lift up slightly on the bolt with your forefinger and remove the bolt
handle through the ejection port.
Fig. 15
Continue to lift up on the bolt while slowly letting it come forward to rest against
the barrel. Reposition your forefinger grip and insert a finger through the ejection
port (Fig. 16). Maneuver the bolt assembly completely up and out of the receiver.
Remove the bolt spring and bolt spring guide rod (Fig. 17a).
Fig. 16
No further disassembly should be done by the owner. If service is required, con-
tact the factory authorized service center or a qualified gunsmith.
16
Fig. 14
Using the operating handle, pull the bolt rearward until you can insert your fore-
finger in front of the bolt. Be careful not to pinch your finger between the bolt face
and the barrel. Lift up slightly on the bolt with your forefinger and remove the bolt
handle through the ejection port.
Fig. 15
Continue to lift up on the bolt while slowly letting it come forward to rest against
the barrel. Reposition your forefinger grip and insert a finger through the ejection
port (Fig. 16). Maneuver the bolt assembly completely up and out of the receiver.
Remove the bolt spring and bolt spring guide rod (Fig. 17a).
Fig. 16
No further disassembly should be done by the owner. If service is required, con-
tact the factory authorized service center or a qualified gunsmith.
16
Fig. 14
Using the operating handle, pull the bolt rearward until you can insert your fore-
finger in front of the bolt. Be careful not to pinch your finger between the bolt face
and the barrel. Lift up slightly on the bolt with your forefinger and remove the bolt
handle through the ejection port.
Fig. 15
Continue to lift up on the bolt while slowly letting it come forward to rest against
the barrel. Reposition your forefinger grip and insert a finger through the ejection
port (Fig. 16). Maneuver the bolt assembly completely up and out of the receiver.
Remove the bolt spring and bolt spring guide rod (Fig. 17a).
Fig. 16
No further disassembly should be done by the owner. If service is required, con-
tact the factory authorized service center or a qualified gunsmith.
16
135055_PN 17925 Rev E.indd 16 1/4/13 9:57 AM