Lumagen VisionDVI & VisionHDP - Manual (Page 7)

VisionHDP ™
User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 4 Rev 1.14
User Guide
This section describes the user interface for everyday functions. For initial setup information see
the Installer Guide section (page 6).
User commands can be entered with the supplied infrared remote control, or using the RS232
serial control port. Contact the installer for information on user commands if the RS232 serial
port is used.
Remote Control
The infrared remote control is shown below.
Configuration
Input Selection
Input Aspect
Ratio Selection
Numeric Entry
and
Input Selection
Power
and
Standby
Image
Zoom
Input Aspect
Ratio Selection
Step
Input Aspect
Ratio Selection
Step
Activate Menu
Exit/Cancel
Command completion
and OSD