Lumagen VisionDVI & VisionHDP - Manual (Page 27)

VisionHDP ™
User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 24 Rev 1.14
MENU → IN→ CONFIG→ DVI→ EDID→ (USER, DFLT+EXT, DFLT, PASS, OFF) OK
NOTE:
After you change the EDID information, many sources require you to cycle power on
the source or unplug the DVI cable to get the source to re-read the EDID.
DVI input Hotplug Mode
Each Lumagen DVI input sends a signal (Hotplug) back to the DVI source to inform the source to
drive its DVI output. However, some sources behave differently to the Hotplug signal. This
command selects how the Lumagen DVI input Hotplug signal functions. The NORM option
asserts Hotplug only when the respective Lumagen input is selected. The ON option always
asserts the Hotplug signal, at all times, while the Lumagen is turned on. Typically, NORM is used
to connect to an HDCP encrypted source and ON is used to connect to a PC.
MENU → IN → CONFIG → DVI → HOTPLG → (NORM, ON) OK
Serial-Digital-Interface Video Input
The Serial-Digital-Interface provides a digital connection for a DVD, or other source, that is
equipped with an SDI output. The setup is similar to other inputs, except SDI does not require
some of the setup controls that are needed for other inputs. The SDI input is set for a default
cable length of
≤ 10 meters. If a longer cable is used, enable the SDI cable equalization as
follows:
MENU 0 9 7 4 Toggle SDI cable equalization (default is off)
Copy Input Settings
Copy the input setup (contrast, etc.) from the active memory, to the selected memory or
memories. Copying the first input memory calibrated to other input memories can speed up the
calibration process. Note that copying a SD input to a HD input, copies the SD memory to (only)
the SD submemory of the HD input. The HD submemories for the PC, 720p and 1080i resolutions
are not changed. Copying a HD input memory to a SD input memory copies the SD submemory
of the HD input to the SD memory. Copying a HD input memory to another HD input memory
copies both the SD submemory and the HD submemory to the other HD input memory.
The input memory copy command can copy all memory parameters (COPY -> ALL), or just the
color (COLR) menu (COPY -> COLOR) parameters. This later function is useful when color and
grayscale are calibrated after the geometry calibration has already been completed for each
input. The color parameters are black, contrast, color, Hue, color offsets, Hue offsets, and
grayscale. The command format is:
MENU → IN→ COPY→ (ALL, COLOR)→ (ALL, ALLMEMA – ALLMEMD, 1A – 0D) OK