Lumagen VisionHDQ - Manual (Page 30)

VisionHDQ ™
User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 27 Rev 1.14
Other Commands
Freeze frame MENU 0 9 0 0 Freeze picture (RS232 code = ‘z’). Any button exits
S/W Rev MENU 0 9 0 3 Display software revision, save-count and serial-number
Video/Film flag MENU 0 9 1 8 Display input type on screen as video (V) or film (F)
Input Reselect MENU 0 9 1 9 Ignore reselection of same input
TV Black MENU 0 9 3 6 TV decoder black
TV Contrast MENU 0 9 3 7 TV decoder contrast
TV MV Black MENU 0 9 3 8 TV decoder Macrovision black offset
TV MV Contrast MENU 0 9 3 9 TV decoder Macrovision contrast offset
In 3,4 sync level MENU 0 9 4 4 Adjust sync-sense level for input 5 or 6
Saving the Configuration
Save
NOTE:
If a save command is not executed, any changes will be lost when the
unit is put into standby power mode, or if power is interrupted.
Permanently save the current configuration. Note that, once saved, the configuration is retained
even if the unit is disconnected from power. Configuration from previous save is retained to allow
one-level of save-undo. The command format is:
MENU → SAVE → SAVE OK OK
Save Undo
Revert to the configuration over-written by the last save. Repeating the save undo command
toggles between the last two saved configurations. The command format is:
MENU → SAVE → UNDO OK OK
Revert To Factory Settings
Set all parameters to factory defaults. A SAVE is required to make permanent. The command is:
MENU 0 9 9 9 Same as MENU → SAVE→ FCTRY OK
Restore Configuration Saved during calibration
During calibration, the video technician can save the resulting Lumagen configuration to a special
hidden configuration memory. This command restores that configuration in the event that the
user inadvertently changes the configuration. A SAVE is required to make the restore
permanent. The command format is:
MENU → SAVE→ RESTORE OK
Revert To Defaults For Current Output Resolution
Sets output parameters to defaults for the current output resolution. A SAVE is required to make
permanent. The command is:
MENU 0 9 9 8 Same as MENU → SAVE→ FCTRY OK