Lingenfelter L460015297 Lingenfelter LNC-001 Launch Controller v3.02 - Manual (Page 8)

85
86
30
87 87a
C
NO NC
1 - Locate CPP (Clutch Position Switch) and unplug 2-wire connector.
2 - Cut wires appox. 3" back from connector.
3 - Find +12 volt Key On power source and connect to one wire of CPP connector.
+12V Key On Power
To LNC-001 +12V Activation
Ground
Connect wires cut from CPP
Switch connector in Step 2
to Relay as shown.
1
2
3
4 - Splice two wires onto remaining CPP connector wire and connect one wire to #85 on Relay.
The extra wire will be used for LNC-001 Launch Controller activation.
5 - Connect terminal #86 on Relay to Ground.
6 - Connect wires cut from CPP Switch connector to Terminals #30 and #87 as shown.
Wire color may vary for model/year.
4
5
6
1998-2002 F-Body and 1998-2005 Corvette Factory Clutch Switch Diagram
General purpose
Automotive Relay.
5 to 40 Amp
Wire color illustrated is for 1999 TransAm
Page 7 of 13