Lingenfelter L460015297 Lingenfelter LNC-001 Launch Controller v3.02 - Manual (Page 4)

Page 3 of 13
Red LED:
• Comes on solid on start-up (power on) in standard mode
• Comes on blinking on start-up (power on) in Programming mode
• When active RPM is reached, LED will blink (even if activation
wire is not triggered)
Green LED:
• Comes on solid when activation wire is triggered (on whenever
powered up in RPM limiter mode)
• Blinks retard count on start-up (power up) when Retard Mode
enabled.
Settings:
• Controlled by two (2) ten position switches
o
Two (2) switches for selecting 1000 rpm and 100 rpm scale
o
View module with wires exiting top, and 0 at 12 o’clock on RPM selector switches
Notes:
• The LNC-001 will not trigger at RPM levels below 1500 rpm
• Changes to the rpm switch point settings must be done with the ignition off
o
The switch positions are only read on start up
Example settings:
• 2500 rpm activation point for launch control
o
Left (X000) rpm switch on position 2
o
Right (0X00) rpm switch on position 5
0
5
6
78 9
1
2 34
0
5
6
78 9
1
2 34
100's Switch
1000's Switch
RPM Programming
Switches
•
7200 rpm activation point for RPM limiter
o
Left (X000) rpm switch on position 7
o
Right (0X00) rpm switch on position 2
0
5
6
78 9
1
2 34
0
5
6
78 9
1
2 34
100's Switch
1000's Switch
RPM Programming
Switches