Lingenfelter L460015297 Lingenfelter LNC-001 Launch Controller v3.02 - Manual (Page 6)

Page 5 of 13
Installation:
•
Make sure the ignition is off before beginning installation.
• Do NOT mount the LNC-001 directly on top of the engine
or near the exhaust manifolds due to heat concerns.
• Do NOT mount the LNC-001 in the line of site of high
temperature objects such as exhaust manifolds, turbine
housings etc. If needed, put a heat shield in between the heat
source and the module to protect the plastic case.
• Do NOT install within 6” of nitrous solenoids or other
devices with strong magnetic fields.
• If you have relocated coil packs, do not run the high voltage
spark plug wires along side the low voltage coil pack wires. Keep the wires as far apart as possible
and, if they do have to intersect, have them intersect at right angles.
• Disconnect the pack connectors on each side of the engine and then plug the LNC-001 wiring
harnesses in between on each side. It does not matter which bank of cylinders each side of the LNC-
001 harness connects to.
Setting The Spark Timing Retard Value:
1 – Set the 100’s RPM programming switch to the desired setting. The actual setting will be the switch
setting + 1. Example to set 5 degrees of retard you would set the 100’s switch to 4.
0
5
6
78 9
1
2 34
0
5
6
78 9
1
2 34
100's Switch
1000's Switch
RPM Programming
Switches
2 – Once you have set the desired degrees of Timing Retard move the 1000’s RPM programming switch to
a non-zero position. At this time the Timing Retard setting is saved.
0
5
6
78 9
1
2 34
0
5
6
78 9
1
2 34
100's Switch
1000's Switch
RPM Programming
Switches
4 – The Green LED will now blink a pattern to show the Timing Retard setting (for above example, 5
blinks to indicate 5 degrees of retard).
5 – Turn power off. Set the desired 2-Step RPM and the LNC-001 is ready for operation in Retard Mode.