Lingenfelter L460015297 Lingenfelter LNC-001 Launch Controller v3.02 User Manual
Page 2
Parts List
#
Part number
Description
1
LNC-001R
LPE Launch Controller with timing retard function
1
48” trigger wire harness
(part of PN LNC-001R)
2
hook & loop tape, 3.5” length
2
AV16037
self-tapping screw
1
L920010000
LPE decal
1
instructions
Optional Items
• momentary switch
• relay
• toggle switch
• noise suppression diode (for use with line-locks & other solenoids - L450080000)
• MPH activated switch to disable the launch control once you are moving (L460050000)
• LED for indicator light
•
Red 12 vdc LED with 30 cm leads (L450030000)
•
Green 12 vdc LED with 30 cm leads (L450040000)
Specifications:
•
40 MHz 16-bit automotive qualified processor with eight channel Enhanced Time Module.
•
Each coil drive circuit has a dedicated timer to keep the timing accurate over the full RPM range.
•
Independent coil drive provides Sequential Ignition Kill when RPM limiting is active.
•
Reverse battery protection.
•
Both of the activation inputs have active clamps and optical isolation to suppress electrical noise
from external solenoids (such as trans brake and line lock).
•
Digital filter provided in software to further isolate electrical noise on the activation inputs.
•
Both Ground Activation and +12 Volt Activation inputs are provided to work with existing vehicle
wiring. Both activation wires may be connected together to enable activation. This allows for the use
of a momentary switch for activation.
•
The LNC-001 can be adjusted from 1500 rpm to 9,900 rpm in 100 rpm increments by the two 10
position rotary switches found inside the module.
•
True plug-and-play design for ease of installation and removal.
•
Fully encapsulated (potted) construction for added durability.
•
Rated for operation at up to 185 degrees F (85 degrees C).
•
90 day warranty (from date of purchase).
•
DO NOT place in direct exposure to exhaust manifolds, turbocharger turbine housings or other
underhood items that are high temperature heat sources (radiated heat sources). The warranty does
not cover damage due to melted enclosures or wiring due to improper installation.
•
Do NOT submerge Controller in liquid or directly wash unit with liquid of any type! (Do NOT
spray when washing vehicle!)
Page 1 of 13