Lingenfelter L460015297 Lingenfelter LNC-001 Launch Controller v3.02 - Manual (Page 7)

Page 6 of 13
• The only wiring that is required is for the trigger wire(s) depending on how you want to enable the
device. See pages 7,8,9,10 & 11 for specific wiring diagrams. The possible connection methods are:
•
ground activation wire (green) - connect this wire to a source that supplies a ground path when
you want the LNC-001 to become active
• +12 volt activation wire (yellow) - connect this wire to a source that supplies +12 volts when
you want the LNC-001 to become active (i.e. brake light switch, line-lock solenoid)
• switch connected in between the ground activation wire and the +12 volt activation wire (green
wire connected to yellow wire through a switch, usually a momentary switch)
• ground activation wire connected to +12 volt activation wire (green connected to yellow) for
standard rpm limiter operation (LNC-001 always active)
• Set the desired RPM switch activation point using the two ten position rotary switches for the 1000
rpm increment (X000) and the 100 rpm increment (0X00), as labeled on page 3.
The LNC-001 is designed for use on all GM LS series engine applications (LS1, LS6, LS2, LS7, LQ4
and other Gen III and IV GM V8 applications along with other GM V8 engines using the same ignition
coil system) including the following vehicles:
•
1997-2004 C5 Corvette
•
2005-2008 C6 Corvette (including Z06)
•
1998-2002 LS1 V8 equipped Camaro and Firebird
•
2004-2006 Pontiac GTO
•
2004-2006 Cadillac CTS-V
•
1999-2008 GM CK trucks (Tahoe, Yukon, Escalade, H2, Sierra, Silverado, Avalanche) with the
4.8, 5.3, 6.0 and 6.2L Gen III and IV V8 engines (will not work on 305 & 350 Vortec engines)
•
2003-2006 Chevrolet SSR
•
2006-2007 Trailblazer SS and other S/T body trucks with the 4.8, 5.3 and 6.0L Gen III & IV GM
V8 engines
The LNC-001 should function on the following vehicles/engines but has not yet been tested on them:
•
CK trucks with 8.1L V8 engines (L19) with individual coil ignitions
•
front wheel drive 5.3L LS4 Gen IV V8 equipped cars (Impala SS, Grand Prix & Monte Carlo)
The LNC-001 should also function with these products but has not yet been tested with them:
•
aftermarket coils for the LS series engines (such as the MSD coils) used with GM ECM/PCM.
•
aftermarket engine management systems and ignition systems (Accel, BigStuff3, Motec, FAST,
MSD, etc.) that run the production GM coils.
Important Information - you must use Noise Suppression Ignition Wires with this Controller. The
LNC-001R Controller contains High Frequency Digital Electronics and will NOT function correctly
without Suppression Wires!