Konig Electronic Wireless alarm system - Manual (Page 30)

- 30 -
ADVANCED PROGRAMMING
Erase Keychain / Keypad Remotes
1
2
3
[PROG]
[MPIN] Enter
Programming
mode Enter master
password to pro-
gramming mode 3 beeps for valid
password. 1 long beep
for invalid password.
[0] Select erase
remote
programming After [0] is entered, some
zone LEDs will flash or stay
off. The zone LEDs
represent whether that zone
is occupied by any remote.
** See Table B below.
Select remote
location you
would like to
erase After you have selected the
remote location, you will hear 3
beeps and verbal confirmation
[Device X Empty Memory],
where X is the remote location
you have selected. To erase
an occupied
remote, press
[6] to [0]. Select a remote
location [6], [7],
[8], [9] or [0].
Remote [6] is represented by zone LED 1
ZONE LED DESCRIPTION
Off Zone is not occupied by any remote
Flashes twice This zone is occupied by a remote. You msy select this zone to erase
this remote
** `Table B: Zone LED status for erasing keychain remote(s).
Step Keys Function Description Note
ZONE LED REMOTE LOCATION
1 6
2 7
3 8
4 9
5 0