Advanced programming – Konig Electronic Wireless alarm system User Manual
Page 25
- 25 -
ADVANCED PROGRAMMING
Follow the procedures below to program the beep / alarm setting.
1
2
[PROG]
[MPIN]
Enter Programming
mode
Enter master
password to
programming mode
3 beeps for valid password.
1 long beep for invalid
password.
[5]
Select Beep /
Alarm Setting
After [5] is entered, some zone
LEDs will flash or stay on.
This indicates whether that
zone is set to beep or alarm.
3
Set to Beep:
[1] to [5]
Set to Alarm:
[6] to [0].
Select which
zone you would
like to Beep or
Alarm.
Refer to the
diagram below to
select the appro-
priate setting.
If Alarm is set for that zone,
that zone LED will be on. If
Beep is set, the LED will
flash. You are allowed to
make multiple changes before
terminating programming
mode.
4
[PROG] when
finished.
Terminate pro-
gramming mode.
PROG LED will be off, and
you will hear 3 beeps.
Zone 1
BEEP
Button [1]
ALARM
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
Example:
If you would like to change the setting for zone 5 from “Beep” to “Alarm”, simply
press [0] at step 3.
This will change the zone 5 setting to “Alarm”.
This row :
Buttons for Beep
Zone LED : Flash
This row :
Buttons for Alarm
Zone LED : ON
Step
Keys
Function
Description
Note