Konig Electronic Outdoor IP camera remote video surveillance - Manual (Page 6)

ENGLISH
6
3
Programme Loading
The status LED will flash red for about 15 seconds.
4
Press the WPS button on your IP camera
Wait until the status LED flashes between red and green, then
press and hold the WPS/RESET button on your IP camera for about
2 seconds to enter WPS mode. The status LED will be flashing
green.
5
Enter WPS mode on the Wi‑Fi router
Press the WPS button on the Wi-Fi router
6
Selecting the Wi‑Fi router
Select the Wi-Fi router of your choice in the screen (see “Figure 9”).
Then select the tab
to enter next step
(see “Figure 10”).
Figure 8 Figure 9 Figure 10
7
IP camera connects with Wi‑Fi router
Wait about 1-2 minutes. If the IP camera is successfully connected
to the Wi-Fi router, the status LED will become orange.
Otherwise the status LED will become a flashing red light. If the
setup is not successful, please go back to Step 1 and try again.
8
If successful, select the tab: (see “Figure 11”), and
follow the instructions.