Konig Electronic Outdoor IP camera remote video surveillance - Manual (Page 3)

ENGLISH
3
2
After the software installation is
complete, click the icon to
run the app.
Default “uCare Cam” password:
0000
Manager’s Name: admin
Manager’s Password: 0000
Figure 1
“Camera List Window”
There are two options to continue the easy set up of your IP camera.
Install your IP camera by ROUTER MODE
1
Power On
Plug the power adapter DC connector into the DC input port of the
IP camera and then plug the power adapter into a wall outlet. The
status LED on the IP camera will turn green for about 15 seconds.
2
Programme Loading
The status LED will flash red for about 15 seconds.
3
Router Link Mode
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset
button for more than 10 seconds to restart the IP camera.
When the green status LED lights up and holds, and then the red
status LED flashes twice, after which it changes into green, the
IP camera has entered the RESET state. At this moment you can
release the button and then wait until the status LED alternates
between red and green.
ANDROID (for Apple go to: Step 8)
Set the IP camera to connect to the Wi‑Fi Router