Hatteland Display HT B18 (Fanless) - Manual (Page 19)

19
IND100133-41
Physical Overview - HT B17
Front area of computer
Reset Button, Power LED & Button 2.5” internal S-ATA SSD Hard Drive
Power LED & Button:
To turn ON the computer, press down button and release it immediately. The Power LED indication riing will illuminate
green and the operating system will automatically boot. To turn OFF the computer, press down this button and hold it
for 4 seconds. The operating system may require additionally tasks to be performed before computer shuts down and
turns off the unit.
Reset Button: (Hard Reset)
To reset the computer in case of severe software failure, press this button. This reset button is a hard reset which
means the operating system will NOT be warned. Using this reset method may damage files and / or operating system
in worst case scenarios. Precaution should be taken when using this. To perform a safe software reset, press either
the power button, or use the operating system own reset functionality if possible.
2.5” internal S-ATA SSD Hard Drive:
The B17 unit can use 1 x SSD, 2.5” as the main data storage device. The operating system and all other files will
be placed on this, normally visible as drive C: This device is normally factory installed option. The storage device is
located inside the unit and can not be accessed/replaced from the outside.