Hanna Instruments HI 5000 - Manual (Page 8)

8
Specifications HI 9913
RANGE 0.00 to 14.00 pH and 0.00 to 10.00 mS/cm (EC)
RESOLUTION 0.01 pH and 0.01 mS/cm
ACCURACY ±0.02 pH and ±2% F. S.
(@20°C/68°F)
TYPICAL EMC
±0.1 pH and ±2% F. S.
DEVIATION
CALIBRATION
WEIGHT 1.6 Kg (3.5 lb.)
ENCLOSURE 181 x 221 x 142mm (7.1 x 8.7 x 5.6")
CASE MATERIAL Fiber-reinforced, self-extinguishing ABS
SETPOINT RANGE From 4.0 to 7.0 pH and 1.0 to 4.0 mS/cm (EC)
PROPORTIONAL
CONTROL
ALARM
CONTACT
POWER SUPPLY 220/240V or 110/115V at 50/60Hz
DOSING
TERMINALS
ENVIRONMENT -10 to 50°C (14 to 122°F)
max. 95% RH non-condensing
Through "OFFSET" and "SLOPE" trimmers for pH, and
“ZERO CAL” and “SLOPE CAL” for Conductivity (EC)
Two independent controls: pH from 0.0 to 2.0 and
Conductivity (EC) from 0.0 to 2.0 mS/cm with two
separate time cycles from 0 to 90 seconds
Terminals can be configured as normally open or
normally closed (isolated output Max. 2A, Max. 240V,
resistive load, 1,000,000 strokes). The alarm is
activated if pH falls below the setpoint by the user-
selectable interval (0.0 to 2.0 pH), or conductivity
exceeds the setpoint by more than the user-selectable
interval (0 to 2.0 mS/cm) or due to overdosage
Two sets of independent terminals (115 to 240V,
Max.2A, 1,000,000 strokes) are activated whenever
pH exceeds the pH setpoint and/or conductivity falls
below the EC setpoint
PROBE Any combination pH electrode with a universal BNC
connector and Hanna Conductivity 4-ring
potentiometric probe with built-in temperature sensor
and DIN connector (optional)