Hanna Instruments HI 5000 - Manual (Page 3)

3
PRELIMINARY EXAMINATION PRELIMINARY EXAMINATION PRELIMINARY EXAMINATION PRELIMINARY EXAMINATION PRELIMINARY EXAMINATION
GENERAL DESCRIPTION GENERAL DESCRIPTION GENERAL DESCRIPTION GENERAL DESCRIPTION GENERAL DESCRIPTION
Remove the instrument from the packing material and examine it
carefully to make sure that no damage has occurred during ship-
ping. If there is any noticeable damage, notify your Dealer.
Note: Save all packing materials until you are sure that the
instrument functions correctly. Any defective item must be
returned in the original packaging together with the supplied
accessories.
IMPORTANT:
1. Read the instructions before using the instrument.
2. The instrument should be connected to a mains socket.
3. Never install the controller outdoors, in a wet or humid area or
under direct sun light. Nor install the controller where liquids
may be sprayed or poured on it.
4. The instrument’s main power line as well as the dosage and
alarm terminals are protected by separate 2A fuses. Use only 2A
fuses for replacement.
Hanna's wall-mounted conductivity/TDS and pH controllers are
designed to meet a variety of process control requirements, especially
those in horticultural, hydroponics and agricultural applications on
the one hand and boilers and cooling towers on the other.
All controllers provide for two separate relays, one for pH and another
for Conductivity/TDS. HI 9913 and HI 9935 also come with propor-
tional control to save on use of chemicals and fertilizers.
All models operate with the optional Hanna 4-ring probes to provide
a linear and repeatable measurement. The conductivity/TDS probes
can be installed quickly and easily. Simply plug the DIN connector
into the socket and tighten the retainer ring.
The EC/TDS probes incorporate a temperature sensor and the control-
lers will automatically compensate for the temperature effect. Accurate
measurements are displayed on a large LCD.
Similarly, the pH electrode can be installed quickly and easily. Simply
plug the universal BNC connector into the socket and twist it into a
secured position. In order to avoid electrical noise and interference,
the pH circuitry also provides for a ground probe (differential input).