Delta Electronics SPBD-1250B4Q1R - Manual (Page 4)

SPBD-1250B4Q1R
DELTA ELECTRONICS, INC.
4 Revision: S1
03/12/2007
www.deltaww.com
5. Electrical Interface Characteristics
Parameter Symbol Min. Typ. Max. Unit Note
Transmitter
Total Supply Current
I
CC
A mA Note (1)
Differential Data Input Swing V DT 500 2400 mV
p-p
Differential line input Impedance R
IN
80 100 120 Ohm
Transmitter Disable Input-High V
DISH
2 V
CC
V Note (2)
Transmitter Disable Input-Low V
DISL
0 0.8 V
Transmitter Fault Output-High V
TXFH
2 V
CC
+0.3 V
Transmitter Fault Output-Low V
TXFL
0 0.8 V
Transmitter Fault Pull up Resistor R
TX_FAULT
4.7 10 kΩ Note (3)
Receiver
Total Supply Current
I
CC
B mA Note (1)
Differential Data Output Swing V DR 400 900 mV
p-p
Note (4)
LOS Output Voltage-High V
LOSH
2 V
CC
+0.3 V
LOS Output Voltage-Low V
LOSL
0 0.8 V
Receiver LOS Load R
RXLOS
4.7 10 kΩ Note (3)
Note (1). A (TX)+ B (RX) = 300mA
(A: Not include termination circuit; B: using a resister of 150Ω between Data-output and ground)
Note (2). There is an internal 4.7 to 10kΩ pull-up resistor to VccT.
Note (3). Pull up to V
CC
on host Board.
Note (4). Internally AC coupled with CML output, but requires a 100Ohm differential termination at or
internal to Serializer/ Deserializer.