Hall Research HR-4P User Manual
Page 9
Programmable Serial Controller
9
Up to 32 IR Codes that have been „learned‟ can be transmitted from the unit.
Select the desired Condition, change Action to IR, change IR Protocol to Memory Recall and select the desired
location that the IR code was saved into.
When done, click the Add button to append the command as shown in Figure 7.
Figure 7
– IR Memory Recall
Time Delay
Time delay‟s can be added to configuration strings as needed. Delay‟s can from milliseconds to 255 minutes.
Multiple delays can be entered if longer times are required.
When done, click the Add button to append the command as shown in Figure 8.
Figure 8
– Time Delay
Output
If any of the units I/O is configured as an output, you can control that output based on a specific input condition.
Select the Output from the Action drop-down menu and pick a desired output channel state, either ON or OFF.
When done, the user clicks the Add button to append the command as shown in Figure 9.